若在輕質隔墻板安裝之前，就預先鑿出埋線的溝槽。施工完成后，可以直接依照圖紙，鑿出埋線的位置，將電線裝置進預鑿槽中，埋線工程即可完成。省時又省力，節(jié)約人力本錢，大大縮短了工期。若未預鑿埋線槽，可按下述方法進行。

If the embedded groove is chiseled out in advance before the installation of light partition board. After the construction is completed, the position of buried wire can be chiseled directly according to the drawing, and the wire can be installed into the pre chiseled groove, and the buried wire project can be completed. Save time and labor, save manpower and cost, and greatly shorten the construction period. If the embedded trunking is not pre chiseled, it can be carried out according to the following methods.

在砌完墻（或批蕩）后，電工進場依照線路走向，用工具在輕質隔墻板墻體上，開槽砸洞，用水管鉤固定線管，也可同時穿線安放線盒、開關箱等，用水泥砂漿稍為固定，等泥水工批蕩或扇灰，步驟繁瑣，效率不高，特別是碰到大面積的工廠，需要埋線時，就會延長工期，費時費力。

After the wall (or swing) is built, the electrician enters the site, according to the line direction, uses tools to slot and smash holes on the light partition board wall, and uses water pipe hooks to fix the line pipe. At the same time, the line box and switch box can also be threaded, slightly fixed with cement mortar, and wait for the plasterer to swing or fan the mortar. The steps are cumbersome and the efficiency is not high, especially when it is necessary to bury the line in a large area of factories, It will prolong the construction period, which is time-consuming and laborious.

若普通紅磚墻在砌磚墻時，需要同時將線管，按線路走向，砌進墻體內，這要電工與泥水工配合停止，這種辦法用得較少，它需求兩工種人員親密配合，工程才能做的出色。

If the common red brick wall needs to build the line pipe into the wall according to the line direction at the same time when building the brick wall, it needs the cooperation of electricians and masonry workers. This method is rarely used. It requires the close cooperation of personnel of the two types of work, so that the project can be done well.